alpos side_shift_on_exit ssoe Trendsetter_400/800_Auto This value specifies the amount of side-to-side shift of the plate after rotation. Setting this parameter to a positive value will shift the plate to the left after rotation (when viewed from the front of the Trendsetter). Setting this value negative will shift the plate to the right. int32
  • 0
    •
  • -100 to 100 [mm]
    •      It is possible to shift very large plates so far that they will hit the back of the machine during rotation. Do not decrease the alpos ssoe parameter past about -50mm for 44" plates. This parameter is only present in firmware versions after and including V1.30. cal
  • ../nvs/al_cfg_ri.xmlNVS: al ri
  • ../nvs/bay_state_rp.xmlNVS: bay rp
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:23 2008 PST